Brocade Fabric OS Message Reference - Supporting Fabric OS v5.3.0 (53-1000437-01, June 2007)

Fabric OS Message Reference 391
53-1000437-01
SEC-1321
63
SEC-1321
Message <timestamp>, [SEC-1321], <sequence-number>,, ERROR, <system-name>, Failed secure
mode enable command. Reason:
<Reason>.
Probable Cause Indicates that the security enable failed on the fabric because switch has conflicting configuration
such as fabric wide consistency configuration or AD configuration.
Recommended
Action
Verify that the security event was planned.
If the security event was planned, run the fddcfg --fabwideset “” command or ad --clear
command to clear the fabric wide consistency configuration or AD configuration and retry the
secModeEnable command.
Severity ERROR
SEC-1322
Message <timestamp>, [SEC-1322], <sequence-number>,, WARNING, <system-name>, Some DCC
policy is too large, distribution cancelled
Probable Cause Indicates that this fabric is not able to support a device connection control (DCC) policy with more
than 256 ports.
Recommended
Action
Reconfigure any policy that includes more than 256 ports in its member list, then save the policy
configuration changes.
Severity WARNING
SEC-1323
Message <timestamp>, [SEC-1323], <sequence-number>,, INFO, <system-name>, Key(s) \"<Key
Name>
\" ignored during configdownload.
Probable Cause Indicates that the specified key is ignored during configDownload.
Recommended
Action
Verify that the event was planned. If the event was planned, no action is required. If the event was
not planned, take appropriate action as defined by your enterprise security policy.
Severity INFO