Brocade Fabric OS Message Reference - Supporting Fabric OS v5.3.0 (53-1000437-01, June 2007)
402 Fabric OS Message Reference
53-1000437-01
SULB-1009
66
"Standby CP booted up." 0x65
"Active and Standby CP failed to gain HA synchronization within 10 minutes." 0x66
"Standby rebooted successfully." 0x67
"Standby failed to reboot." 0x68
“firmwareCommit has started to restore the secondary partition.” 0x69
"Local CP is restoring its secondary partition." 0x6a
“Unable to restore the secondary partition. Please use firmwareDownloadStatus and
firmwareShow to see firmware status.”
0x6b
“firmwareDownload has started on Standby CP. It might take up to 10 minutes.” 0x6c
“firmwareDownload has completed successfully on Standby CP.” 0x6d
"Standby CP reboots." 0x6e
"Standby CP failed to boot up." 0x6f
"Standby CP booted up with new firmware." 0x70
"Standby CP failed to boot up with new firmware." 0x71
“firmwareDownload has completed successfully on Standby CP.” 0x72
“firmwareDownload has started on Standby CP. It might take up to 10 minutes.” 0x73
“firmwareDownload has completed successfully on Standby CP.” 0x74
"Standby CP reboots." 0x75
"Standby CP failed to reboot." 0x76
“firmwareCommit has started on Standby CP.” 0x77
“firmwareCommit has completed successfully on Standby CP.” 0x78
"Standby CP booted up with new firmware." 0x79
"Standby CP failed to boot up with new firmware." 0x7a
“firmwareCommit has started on both Active and Standby CPs.” 0x7b
“firmwareCommit has completed successfully on both CPs.” 0x7c
“firmwareCommit failed on Active CP.” 0x7d
"The original firmware has been restored successfully on Standby CP." 0x7e
"Unable to restore the original firmware on Standby CP." 0x7f
"Standby CP reboots." 0x80
"Standby CP failed to reboot." 0x81
"Standby CP booted up with new firmware." 0x82
"Standby CP failed to boot up with new firmware." 0x83
“There was an unexpected reboot during firmwareDownload. The command is aborted.” 0x84
"Standby CP was not responding. The command is aborted." 0x85
“firmwareCommit has started on both CPs. Please use firmwareDownloadStatus and
firmwareShow to see the firmware status.”
0x86
TABLE 6 Status Messages and Status Codes
Status Message Status Code