Brocade Fabric OS Message Reference Supporting Fabric OS v6.0.0 (53-1000600-01, October 2007)

Fabric OS Message Reference 63
53-1000600-01
Chapter
7
BM System Messages
BM-1001
Message <timestamp>, [BM-1001], <sequence-number>,, ERROR, <system-name>, BM protocol
version <Protocol version> in slot <Slot number>.
Probable Cause Indicates that the software running on the CP cannot communicate with the AP blade in the
indicated slot, in order to determine AP blade's firmware version. This can be due to one of the
following:
• The CP blade is running a later version than the AP blade.
• The CP blade is running a much older version than the AP blade.
Recommended
Action
The problem can be corrected by changing the firmware version on either the control processor
(CP) or on the application processor (AP) blade. The firmware version on the CP blade can be
changed using the firmwareDownload command. Refer to the release notes to determine whether
a non-disruptive firmware download is supported between the versions. As the AP and CP blades
cannot communicate, it is not possible to load new firmware on the AP blade. If needed, send the
AP blade back to the factory for a firmware update.
Severity ERROR
BM-1002
Message <timestamp>, [BM-1002], <sequence-number>,, INFO, <system-name>, Connection
established between CP and blade in slot
<Slot number>.
Probable Cause The control processor (CP) has established a connection to the blade processor (BP) and can
communicate.
Recommended
Action
No action is required.
Severity INFO
BM-1003
Message <timestamp>, [BM-1003], <sequence-number>,, WARNING, <system-name>, Failed to
establish connection between CP and blade in slot
<Slot number>. Faulting blade.
Probable Cause The control processor (CP) could not establish a connection to the blade processor (BP) to
communicate.