Brocade Fabric OS Message Reference Supporting Fabric OS v6.0.0 (53-1000600-01, October 2007)

Fabric OS Message Reference 85
53-1000600-01
EM-1034
12
EM-1034
Message <timestamp>, [EM-1034], <sequence-number>,, ERROR, <system-name>, <FRU Id> set to
faulty, rc=<return code>.
Probable Cause Indicates that the specified field-replaceable unit (FRU) has been marked as faulty for the specified
reason.
Recommended
Action
Try reseating the FRU.
Run the systemVerification command to verify that the switch does not have hardware problems.
Refer to the Fabric OS Command Reference for more information on this command.
If the message persists, replace the FRU.
Severity ERROR
EM-1035
Message <timestamp>, [EM-1035], <sequence-number>,, ERROR, <system-name>, 2 circuit
paired Power Supplies are faulty, please check the
<Switch side> AC main
switch/circuit to see if it has power.
Probable Cause Suggests that since both Power Supplies associated with one of the 2 main circuits are present but
faulty, maybe the circuit's switch has been turned off, or the AC power source has been interrupted
for that circuit.
The Switch side value is either “left” or “right” designating which circuit switch, facing the cable
side of the chassis. The Switch side value indicates:
• “left”: controls the odd numbered power supply units.
• “right”: controls the even numbered power supply units.
Recommended
Action
Check that the identified AC circuit switch is turned on, that the power cord is properly attached
and undamaged, and that the power source is operating properly.
Severity ERROR