Brocade Fabric OS Message Reference Supporting Fabric OS v6.0.0 (53-1000600-01, October 2007)

Fabric OS Message Reference 419
53-1000600-01
SEC-1301
66
SEC-1301
Message <timestamp>, [SEC-1301], <sequence-number>,, INFO, <system-name>, This switch is
in interop mode. Security is not supported.
Probable Cause Indicates that the switch is interop-mode enabled.
Recommended
Action
Disable interop-mode using the interopMode command before enabling the Secure Fabric OS
feature.
Severity INFO
SEC-1302
Message <timestamp>, [SEC-1302], <sequence-number>,, INFO, <system-name>, This switch
does not have all the required PKI objects correctly installed.
Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can
only occur when the primary fabric configurations server (FCS) is distributing the security database
to the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity INFO
SEC-1303
Message <timestamp>, [SEC-1303], <sequence-number>,, INFO, <system-name>, This software
version does not support security.
Probable Cause Indicates that the currently installed software version does not support the Brocade Secure Fabric
OS feature.
Recommended
Action
Run the firmwareDownload command to update the firmware to the latest version for your specific
switch. Verify that the firmware you are installing supports the Brocade Secure Fabric OS feature.
Severity INFO