Brocade Fabric OS Message Reference Supporting Fabric OS v6.0.0 (53-1000600-01, October 2007)

458 Fabric OS Message Reference

53-1000600-01

TRCE-1009

Message <timestamp>, [TRCE-1009], <sequence-number>,, ERROR, <system-name>, Unable to

alert active CP that a dump has occurred.

Probable Cause Indicates that the standby CP is unable to communicate trace information to active CP. This

message is only applicable to the Brocade 24000 and 48000.

Recommended

Action

Run the haShow command to verify that the current CP is standby and the active CP is active.

If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the

supportSave command and contact your switch service provider.

Severity ERROR

TRCE-1010

Message <timestamp>, [TRCE-1010], <sequence-number>,, ERROR, <system-name>, Traced fails

to start

Probable Cause Indicates that the trace daemon (traced), used for transferring trace files, failed to start. The trace

capability within the switch is unaffected. The traced facility is normally restarted automatically by

the system after a brief delay.

Recommended

Action

If the message persists, reboot the CP (dual-CP system) or restart the switch.

Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command

and contact your switch service provider.

Severity ERROR

TRCE-1011

Message <timestamp>, [TRCE-1011], <sequence-number>,, INFO, <system-name>, Trace dump

manually transferred to target ' <optional string to indicate which slot the dump

is ftped out.> ': <result>.

Probable Cause Indicates that a manual transfer of trace dump files has occurred.

Recommended

Action

No action is required.

Severity INFO