HP StorageWorks Multi-protocol Router Installation Guide (A7437-96003, September 2005)

Overview20
Example
c. After entering the license key, use the licenseshow command to see whether the license is
valid.
If a licensed product is not displayed, the license is invalid.
NOTE: After a license is entered, the licensed product is available immediately; the system does
not require a reboot.
11.Configure the inactive ports.
For example, if you are using the ports for routing and connecting to an edge fabric, use the
portcfgexport command to configure as EX_Port.
Use the portstart command to start the ports. (This command loads the port code, unlike the
portenable command, which enables the port laser.) For example:
portstart 8-15
12.Use the portenable command to enable the ports. For example:
portenable 8-16
Optionally, use the portshow command to verify the status of the newly activated ports is
Started.
NOTE: If you remove the HP StorageWorks MP Router Upgrade License, ports 8 through 15
no longer work after the next reboot.
MPRouter:admin> licenseadd "bQebzbRdScRfc0iK"
License key bQebzbRdScRfc0iK added