HP StorageWorks Multi-protocol Router Installation Guide (A7437-96003, September 2005)

Installation, setup, and login28
Installing the MP Router in a rack using the SAN Switch Rack Mount
Kit
This section provides instructions for installing the MP Router in an HP System/e rack, or in an HP
10000 series rack using the HP StorageWorks SAN Switch Rack Mount Kit supplied with your
router. This installation requires one technician.
The following items are required to install the router in a rack:
• MP Router
• Power cables
• #2 Phillips screwdriver
• 7/16-inch wrench or socket
The SAN Switch Rack Mount Kit rails and rail mounting hardware are listed in Table 7.
Table 7 Rack Mount Kit rails and rail mounting hardware
Item Description
(2) rear mounting brackets
A right inner rail and a right outer rail
A left inner rail and a left outer rail
(14) #8-32 x 3/16-inch Phillips pan-head
screws with thread lock for the SAN Switch
2/32 only.
(14) 8-32 x 5/16-inch Phillips pan-head
SEMS screws for use with the MP Router
(requires six, three on each side, to attach
right and left rails)
(10) #10-32 x 1/2-inch Phillips pan-head
screws with captive star lock washer