HP StorageWorks Multi-protocol Router Installation Guide (A7437-96003, September 2005)

Multi-protocol router installation guide 39
Example
After POST2 completes, various system services start and the boot process displays additional
console status and progress messages. The messages are specific to the fabric, the MP Router, and
the software release.
NOTE: For more information about beaconing, see the HP StorageWorks XPath OS 7.4.x
administrator guide
.
Checking POST results
Check the success/fail results of the diagnostic tests run during POST via LED activity, the error log,
or CLI using the errShow command. For more information about error messages, see the
HP
StorageWorks XPath OS 7.4.x diagnostic and system error messages reference guide
.
*******************************************************************************
* *
* Copyright (c) 2004, *
* MP Router*
* Firmware Version 1.x.x.x.H build #XX: Sat Jan 31 12:40:41 PDT 2004 *
* MAC Address: 00:05:1E:31:2F:60 *
* BCSR FPGA Version 2007 *
* *
*******************************************************************************
1024 MB SDRAM installed
Executing code from SDRAM at 0203B5E0
Power supply 1 status test PASSED
Power supply 2 status test FAILED
Fan tray status 1 test PASSED
Fan tray status 2 test PASSED
SEPROM initialized. SEPROM test is BYPASSED
Dram test #2 is BYPASSED
Compact Flash is installed
Autoboot command: "memboot"
Press <Enter> to execute or any other key to abort.