HP StorageWorks Multi-protocol Router Installation Guide (A7437-96003, September 2005)

Multi-protocol router installation guide 45

CAUTION: The console port can be used to monitor error messages through a serial connection. It

is not recommended as a command interface during normal operation. If this port is not in use,

remove the serial cable and protect the port from dust by replacing the shipping plug.

Record the IP address on the label affixed to the MP Router.

Establishing an Ethernet connection

After using a serial connection to configure the IP address for the MP Router, connect to the Local

Area Network (LAN) if desired.

NOTE: HP recommends connecting the MP Router to a private network or VLAN.

By establishing an Ethernet connection, you can complete the MP Router configuration using either a

serial session or a telnet session. However, you must ensure that the MP Router is not modified from

other connections at the same time.

To establish an Ethernet connection to the MP Router, follow these steps:

1. Insert one end of an Ethernet cable into a management port, as shown in Figure 11 on page 52.

2. Connect the other end to the workstation (or to an Ethernet network containing the workstation).

As a result, the MP Router can be accessed remotely using any available management tool (such

as telnet or Advanced Web Tools). Ensure that the MP Router is not being modified from any

other connections during the configuration process.

3. Complete any additional MP Router configuration procedures through a telnet session.

Setting the domain ID

Each router in the fabric must have a unique domain ID. You can set the domain ID using the

configure command, or allow the domain ID to be automatically set.

NOTE: The default domain ID for the MP Router is 100.

To set the domain ID, follow these steps.

1. Enter the switchdisable command to disable the MP Router.

2. Enter the configure command.

3. Enter a unique domain ID.

Example

Domain: (1..239) [100] 3