HP StorageWorks Multi-protocol Router Installation Guide (A7437-96003, September 2005)

Setting initial parameters50
Removing a license
Use these steps to remove a license from the MP Router.
1. Log in to the MP Router as admin.
2. Enter the licenseremove command, followed by the license key enclosed in double quotation
marks.
Example
3. Remember to save the license key in case you want to reinstall the license in the future.
Verifying operation
Use these steps to verify that the MP Router is set up and connected.
1. Check the LEDs to verify that all components are functional.
2. Enter switchshow to display the MP Router system and port status.
3. Enter fabricshow to display general information about the fabric.
Backing up the configuration
Save all configuration data for the MP Router—including license key information—and upload it to
a host for emergency reference. Back up the configuration on a routine basis to ensure that the
current configuration is available.
Back up the configuration by entering the configupload command.
The configupload command uploads the MP Router configuration to the server so that it is
available for downloading to a replacement MP Router, if necessary. For more information about
this command, see the
HP StorageWorks XPath OS 7.4.x command reference guide .
APswitch:admin> licenseremove "bQebzbRdScRfc0iK"
removing license key "bQebzbRdScRfc0iK"