HP StorageWorks Multi-protocol Router Installation Guide (A7437-96003, September 2005)

Multi-protocol router installation guide 59
* Requirements for running IP over Fibre Channel:
• Must be run on both host bus adapter (HBA) and router.
• Must be supported by both HBA and HBA driver.
MP Router diagnostics
This section describes the CLI commands used to obtain device status, perform diagnostics, and
access event and port log information for troubleshooting purposes.
See the following sections for details:
• Viewing device status, page 59
• Viewing the event log, page 63
• Viewing the port log, page 64
• Using the diagnostic commands, page 65
Viewing device status
The following sections describe how to the view MP Router status and the status of its individual
components.
MP Router status
Use the switchstatusshow command to display the overall status of the MP Router, including its
power supplies, fans, and temperature. If the status of any one of these components is either
Management server
See the
HP StorageWorks XPath OS 7.4.x
administrator guide
and the HP StorageWorks
XPath OS 7.4.x command reference guide.
Ethernet or
serial
connection
Native in-band
interface
(over HBA
only)
Table 17 Management options for the MP Router (continued)
Management tool Out-of-band
support
In-band
support