HP StorageWorks NAS 1000s Quick Start Guide

NAS 1000s Quick Start Guide 31
Remote Access Method (Using Hostname)
The NAS 1000s ships by default with DHCP enabled on the
network port. If the system is placed on a DHCP serviced
network and the serial number of the device is known, it can be
accessed through a client running Microsoft Internet Explorer 5.5
(or later) on that network, using the 3201 port of the device. The
serial number is located on the product ID label.
Requirements
The following items are required to run the WebUI configuration
application:
■ Windows-based PC loaded with Internet Explorer 5.5 (or
later) on the same segment as the NAS 1000s
■ DHCP-serviced network
■ Serial number of the NAS 1000s
Note: The NAS 1000s is designed to be deployed without a monitor,
keyboard, and mouse. These ports are available and supported by
the NAS device, if used.
Procedure
To initialize the NAS 1000s using the WebUI configuration
application:
1. Connect the Ethernet cables to the respective network ports
of the NAS 1000s and the corresponding network segments
in accordance with the information in the “Configuration
Information” section in Chapter 2.
2. See Figure 3 and Table 4 for the locations of the network
ports on the NAS 1000s.
3. Go to the NAS device and power it on. It will be several
minutes before the NAS device is accessible on the network.