HP StorageWorks NAS 1000s Quick Start Guide

NAS 1000s Quick Start Guide 37
Replacing a Failed Hard Drive
Follow these steps to install the hot-pluggable hard drive into the
system.
1. Remove the NAS 1000s front bezel.
a. Locate the two bezel latches found on the side of the
bezel. Pull the latches outward.
b. Pull the front bezel away from the unit.
2. Remove a hard drive from the disk enclosure before installing
a new hard drive.
a. Press the ejector button and pivot the lever to full open
position.
b. Pull the drive from the disk enclosure.
3. Slide the replacement drive into the disk enclosure.
4. The ejector lever must be in the full open position while
installing to ensure a correct latch. When the drive has been
fully inserted, close the ejector lever.
5. With the system powered on, open Logical Disk Manager
(LDM) and follow these steps to reactivate the disk.
a. Open the Run applet from the Start menu and type
diskmgmt.msc.
b. After the failed drive is replaced in the NAS 1000s, the
disk is detected in LDM as Unknown and must be
initialized. If the disk is already detected as a Basic disk,
proceed to step 5c. Right-click the Unknown disk and
select Write Signature.
c. The new hard disk is now detected as a Basic disk.
Upgrade the disk to Dynamic by right-clicking on the
disk and selecting Upgrade to Dynamic Disk as shown
in Figure 6.