NAS 2000s Install Guide

NAS 2000s Installation Guide 25
Procedure
To initialize the NAS 2000s:
1. Connect the Ethernet cables to the respective network ports
of the NAS 2000s and the corresponding network segments.
See Figure 3 and Table 2 on page 14 for the locations of the
network ports on the NAS 2000s.
2. Go to the NAS device and power it on. It will be several
minutes before the NAS device is accessible on the network.
Note: The NAS device will respond when the NAS operating system
has started.
3. Open Internet Explorer on the PC. Enter https://, the
serial number of the NAS 2000s followed by a hyphen (-),
and then
:3202. Press Enter.
Example:
https://D4059ABC3433-:3202
Note: Substitute the server name for the serial number if a server
name was previously set.
4. Click Yes in the Security Alert dialog to accept the security
certificate.
5. Login to the WebUI. This launches the WebUI configuration
application (Rapid Startup) on the target HP StorageWorks
NAS device, as shown in Figure 7.
Note: The default login for the WebUI is administrator and the
password is hpinvent. The WebUI uses the same login as the local
administrator's account or an account with administrative privileges.
6. Go to the next section “Rapid Startup Wizard Configuration,”
to complete the setup procedures.