NAS 2000s Release Notes

18 NAS 2000s Release Notes
The default configuration is:
Array A: Consists of two logical drives and two physical drives in
slots 0 and 1.
Logical Drive 1:
Raid: 1
Size: 27555 MB
Sectors: 32
Stripe Size: 256
Array Accelerator: Enabled
Logical Drive 2:
Raid: 1
Size: 7171 MB
Sectors: 32
Stripe Size: 256
Array Accelerator: Enabled
Note: HP recommends that you do not change the configuration of
Array A.
If the Array and Logical Drive configuration has been altered and
the Quick Restore fails to work properly, use the Array
Configuration Utility to configure the drives as described above.
The Array Configuration Utility is available by booting the
system with the SmartStart CD included with the HP
StorageWorks NAS system.
WARNING: Do not replace the Operating System drives
with drives that were previously configured on another
system. Replace bad drives with ONLY blank, unconfigured
drives. If necessary, install the drives in another system and
use ACU to remove any previous configuration from the
drives.