NAS b2000 - Quick Start Guide

Configuration Setup
NAS B2000 Quick Start Guide 3-3
COMPAQ CONFIDENTIAL
Writer: Darrell Washington File Name: d-ch3 Configuration Setup.doc
Codename: Collins Part Number: 292283-001 Last Saved On: 5/30/02 9:40 AM
Procedure
To initialize the NAS B2000 using the WebUI configuration application:
CAUTION: Do not power up the NAS device until steps 1 through 5 are completed.
1. Connect the Ethernet cables to the respective network ports of the NAS B2000
and the corresponding network segments, in accordance with the information in
the “Configuration Information” section in Chapter 2.
See Figure 3-1 and Table 3-1 for the locations of the network ports on the
NAS B2000.
2. Verify that the Windows-based PC client is connected to the same subnet as the
NAS B2000.
3. Power on the Windows-based PC and wait until the operating system has
completely loaded.
4. Insert the RapidLaunch CD into the CD-ROM drive.
5. The RapidLaunch CD should automatically run. If the program does not start up
automatically, the program may be run manually. Click Start
StartStart
Start, then select Run
RunRun
Run on
the Windows taskbar, and then type the following:
{CD ROM drive}:\setup.exe
Wait for the interface to start up.
6. Go to the NAS device and power it on. It will be several minutes before the NAS
device is accessible on the network.
7. Return to the Windows-based PC. Select StorageWorks NAS from the Show
drop down list to have RapidLaunch list all NAS devices on the network, as
shown in Figure 3-2.