NAS b2000 - Quick Start Guide

Configuration Setup
3-10 NAS B2000 Quick Start Guide
COMPAQ CONFIDENTIAL
Writer: Darrell Washington File Name: d-ch3 Configuration Setup.doc
Codename: Collins Part Number: 292283-001 Last Saved On: 5/30/02 9:40 AM
Procedure
To initialize the NAS B2000 using the WebUI configuration application:
1. Connect the Ethernet cables to the respective network ports of the NAS B2000
and the corresponding network segments in accordance with the information in
the “Configuration Information” section in Chapter 2.
See Figure 3-1 and Table 3-1 for the locations of the network ports on the
NAS B2000.
2. Go to the NAS device and power it on. It will be several minutes before the NAS
device is accessible on the network.
3. Open Internet Explorer on the Windows-based PC. Enter
http://, the serial
number of the NAS B2000 followed by a hyphen (
-), followed by :3201. Press
Enter. This launches the WebUI configuration application (Rapid Startup) on the
target StorageWorks NAS device as shown in Figure 3-4.
Example:
http://D4059ABC3433-:3201
NOTE: The NAS device will respond when the NAS operating system has started.
4. Using the information from Table 2-1, fill in the screens that follow. Verify that
your information is correct when the configuration review screen is displayed, as
shown in Figure 3-5.
5. Click the Finish icon to exit Rapid Startup. Close the browser window. The
NAS B2000 will now reboot to set the configuration information.