NAS Executor e7000 v1 - Quick Start Guide

Configuration Setup
Compaq StorageWorks NAS Executor E7000 Quick Start Guide 3-9
COMPAQ CONFIDENTIAL
Writer: Mark Garza File Name: d-ch3 Configuration Setup.doc
Codename: Eusebio Part Number: 259129-001 Last Saved On: 10/12/01 9:07 AM
Direct Access Method (Via Hostname)
The NAS E7000 ships by default with DHCP enabled on the management port
(Eth 0). If the system is placed on a DHCP serviced network and the serial number of
the device is known, it can be accessed through a client running Microsoft Internet
Explorer 5.5 (or greater) on that network via the 3201 port of the device. The serial
number may be found on the front of the NAS E7000 as illustrated in Figure 3-6.
D4059ABC3433
Figure 3-6: Serial number location
Requirements
The following items are required to run the WebUI configuration application:
• Windows-based PC loaded with Microsoft Internet Explorer 5.5 (or greater) on
the same segment as the NAS E7000
• DHCP serviced network
• Serial number of the NAS E7000
NOTE: The NAS E7000 is designed to be deployed without a monitor, keyboard, and mouse.
These ports are available and supported by the NAS device if used.