NAS Executor e7000 v1 - Quick Start Guide

Configuration Setup
3-10 Compaq StorageWorks NAS Executor E7000 Quick Start Guide
COMPAQ CONFIDENTIAL
Writer: Mark Garza File Name: d-ch3 Configuration Setup.doc
Codename: Eusebio Part Number: 259129-001 Last Saved On: 10/12/01 9:07 AM
Procedure
1. Connect the Ethernet cables to the respective network ports of the NAS E7000
and the corresponding network segments in accordance with the information in
the “Initialization Information” section in Chapter 2. See Figure 3-1 and
Table 3-1 for the locations of the network ports on the NAS E7000.
2. Open Internet Explorer on the Windows-based PC. Enter
http://, the serial
number of the NAS E7000 followed by a dash (
-), followed by :3201. Press
Enter. This launches the WebUI configuration application (Rapid Startup) on the
target StorageWorks NAS device as shown in Figure 3-4.
Example:
http://D4059ABC3433-:3201.
3. Follow the instructions on the screen to input the correct information. Verify that
your information is correct when the configuration review screen is displayed as
shown in Figure 3-5.
4. Click the Online icon to save the network information to the NAS E7000.
5. Click the Finish icon to exit Rapid Startup. Close the browser window. The NAS
E7000 will now reboot to set the configuration information.
6. If the NAS E7000 is being deployed in a cluster configuration, repeat steps 1-4
for the second node.
7. For cluster deployments only. Once the second node has been configured with
Rapid Startup, close the browser window and follow the procedures of the CST
documented in Chapter 4, “Cluster Setup Tool.”
Data Diskette Initialization (Optional Method)
The configuration data diskette method is often used for remote deployments where
network access may not be possible at the time of configuration. This method uses a
wizard interface that gathers the configuration information and writes it to a diskette.
The diskette is then placed in the NAS E7000 upon startup. A keyboard, monitor, and
mouse will be needed for the NAS E7000 to observe the initialization process.