hp StorageWorks NAS e7000 v2 Maintenance and Service Guide

Troubleshooting
119NAS e7000 v2 Maintenance and Service Guide
Note: If the server does not restart, proceed to the section, “Diagnostic Steps.”
8. Check the server for the following normal power-up sequence to be sure that your system
meets the minimal hardware requirements and is powered up during normal operations:
a. The power button LED turns from standby (amber) to on (green).
b. The fans start up. It is normal for the fans to initially run at full speed and then slow
down.
9. View the monitor for the following messages; be sure your system meets the minimal
hardware requirements and is powered up during normal operations:
a. HP StorageWorks logo
b. BIOS information
c. Copyright information
d. Processor initialization
e. Multi-initiator configuration
Note: Select the multi-initiator configuration utility (ctrl-a) only to support HP storage and clustering
options.
f. PXE initialization
g. Option ROMs
h. SCSI devices
10. The operating system loads to complete the boot process.
If the server completes POST and attempts to load the operating system, go to the “Problems
After Initial Boot” section in this chapter.