HP StorageWorks P9000 Performance Advisor Software v5.2 Install Guide (T1789-96317, May 2011)
Sections in the HP StorageWorks P9000 Performance Advisor and Host Agents
Installation Checklist
The prerequisites and tasks provided in the installation checklist are organized as follows:
• Before installing P9000 Performance Advisor: This section lists the tasks and prerequisites you must
complete before starting the P9000 Performance Advisor installation process on your management
station.
• Installing P9000 Performance Advisor: This section directs you to the P9000 Performance Advisor
installation wizard.
• After installing P9000 Performance Advisor: This section lists the post-installation tasks and pre-
requisites that you must complete before installing the P9000 Performance Advisor host agents.
• Installing P9000 Performance Advisor host agents: This section directs you to the P9000 Performance
Advisor host agents installation procedures for the host agents you want to install.
• After installing P9000 Performance Advisor host agents: This section lists the post-installation tasks
and prerequisites that you must complete to login, and configure data collections in P9000 Per-
formance Advisor.
• Using P9000 Performance Advisor: This section lists the procedures to collect configuration and
performance data from your XP and P9000 disk arrays.
Table 2 HP StorageWorks P9000 Performance Advisor and host agents installation checklist
Before installing P9000 Performance Advisor
P9000 Performance Advisor setup prerequisites
Design the infrastructure for P9000 Performance Advisor.
For more information, see “Designing the infrastructure” on page 20.
Determine the coexistence for P9000 Performance Advisor with other storage products.
For more information, see “Determining the coexistence with other storage products” on page 23.
P9000 Performance Advisor management station prerequisites
Consider a management station where Oracle is not already installed
For more information, see “Choosing a system where Oracle is not installed” on page 29.
Verify the supported configuration for the P9000 Performance Advisor management station.
For more information, see “Verifying the supported configurations for P9000 Performance
Advisor” on page 24.
Select a free port (not used by any other application's process and not a commonly reserved port) that
P9000 Performance Advisor can use for all its communications. Port 80 is the default port that can be
used.
For more information, see “Assigning ports for P9000 Performance Advisor on the management
station” on page 31.
Disable the User Access Control (UAC) on your Windows management station, if you want to install
P9000 Performance Advisor.
For more information, see “Disabling UAC on a Windows management station” on page 32.
Understanding the P9000 Performance Advisor installation prerequisites16