HP StorageWorks P9000 Performance Advisor Software v5.3 Install Guide (T1789-96323, August 2011)

chineName>_<timestamp>_OraclePatch.log located under <directory
name>.
After the patch is applied on database binaries, few SQL scripts are executed on the PADB. If the
operation fails, the error message is displayed.
Resolution: Inspect the catbundle_WINBUNDLE_PADB_APPLY_<timestamp>.log and
<MachineName>_<timestamp>_OraclePatch.log files. For further assistance to resolve the
issue, contact your HP Support representative along with the log files.
Installation error messages
This section describes the error messages that you might see when installing P9000 Performance
Advisor. The error messages are presented in the following format:
• Error Title: Provides a brief description of the error
• Error Description: Provides the cause of the error
• Solution or Workaround: Provides the solution for resolving the error, or a workaround
Table 9 Installation error messages
Solution or WorkaroundError DescriptionError Title
For steps on how to configure a static IP
address or Loopback Adapter, refer to the
P9000 Performance Advisor install guide
available on Disk 1.
The installation wizard has detected that
your management station does not have a
static IP address or Loopback Adapter
configured. They should be configured for
the installation wizard to proceed.
Static IP address or
Loopback Adapter
is not configured on
this management
station.
Upgrade the processor speed to 800 MHz
or install P9000 Performance Advisor on
a management station that already has the
processor speed set to 800 MHz or
greater.
The installation wizard has detected that
your management station's processor
speed is less than 800 MHz. It should at
least be 800 MHz for the installation
wizard to proceed.
The processor
speed is less than
800 MHz on this
management
station.
Release the required free disk space on
your management station. The installation
wizard will exit now. After you make the
required disk space available, double click
PA_Server.exe to resume the installation
of P9000 Performance Advisor.
The installation wizard has detected that
sufficient disk space is not available on the
disk drive, where you are trying to install
P9000 Performance Advisor. There must
be at least 8 GB of free space available
for the installation wizard to proceed.
Insufficient disk
space in
<Install_drive>.
Remove Command View XP for the
installation wizard to proceed. For more
information, refer to the Command View
XP install guide. The installation wizard will
exit now. After you remove Command
View XP, double click PA_Server.exe
to resume the installation of P9000
Performance Advisor.
The installation wizard has detected that
an instance of Command View XP is
already installed on this management
station. Command View XP must be
removed before P9000 Performance
Advisor can be installed.
Command View XP
is already installed
on this management
station
HP StorageWorks P9000 Performance Advisor Software Installation Guide 147