HP StorageWorks P9000 Performance Advisor Software v5.3 Install Guide (T1789-96323, August 2011)

TASKKILL /F /PID <Port 80 PID>
Where, <Port 80 PID> is replaced by the process identifier of the task currently using port 80.
Increasing the virtual memory on your management station
Increase the virtual memory for the <Installation_Drive>, where you intend to install P9000
Performance Advisor to the maximum configurable paging file size that your system supports.
To manually allocate the virtual memory (custom page file size) to the <Installation_Drive>:
NOTE:
The steps provided are applicable for the Windows XP operating platform. For increasing the paging
file size on another Windows operating platform, refer to the documentation provided for that Windows
operating platform.
1. Right-click My Computer and select Properties from the pop-up list.
2. In the System Properties window, click the Advanced tab.
3. Under Performance, click Settings.
4. In the Performance Options window, click the Advanced tab.
5. Click Change under Virtual Memory.
6. In the Virtual Memory window, click Custom Size (if not already selected).
7. Provide the maximum configurable custom page file size in the Initial Size (MB) box. The value
that you provide must be equal to the Maximum Size (MB).
By manually adding a custom page file size to the <Installation_Drive>, it also registers
a Page File Size (MB), which is displayed against the corresponding Drive [Volume Label] under
Virtual Memory.
8. Click OK on the Virtual Memory, Performance Options, and System Properties windows to save
the changes, and close the windows.
Disabling UAC on a Windows management station
IMPORTANT:
Applicable only if you want to install P9000 Performance Advisor on a Windows management station,
where UAC is enabled.
UAC controls the installation and removal of programs, and prevents programs from being added to
the registry. Ensure that UAC is disabled before installing or removing P9000 Performance Advisor.
Following is a sample procedure that shows how to disable UAC on a Windows Vista management
station:
1. Go to Start > Run, type msconfig in the command line, and press the Enter key.
The System Configuration window appears.
2. In the System Configuration window, click the Tools tab.
3. Select Disable UAC and click Launch.
Understanding the P9000 Performance Advisor installation prerequisites32