HP XP P9000 Performance Advisor Software v5.5 Command-line User Interface Reference Guide (T1789-96338, February 2013)

ha_rem: requests the management station to remove this host agent from its database.
Required. Specify the host agent system. This can either be a host name or an IP address.
Not necessary if -list is used.
–ha <hostagent>
Lists the host configuration data that is stored on the management station.–list
The output from the -list switch must be labeled, but delimited.–L
Specify the character for delimited output.–d <char>
Displays data in a readable form.–hr
Specify a user name and password pair in the format user name:password.–auth <user:passwd>
Specify the address of a management station in the format <http://
path.to.managementstation:<port>> or <https://
path.to.managementstation>.
–ms <URL>
Prints the usage statement.–?
Example
hostcfg -list –hr
USERHOSTCFG
Syntax
[-filein in_name | -streamin | -database colon:separated:no_spaces]
-fileout out_name -streamout -header -send -ms management_station_name
[-auth user:password | -pf password_file] -?
Supported disk array types
XP and P9000 disk arrays
Description
Enables you to request the host configuration information.
Switches
When repeated, only uses the last in_name.–filein <in_name>
The default input value.–streamin
A list of host names.
TIP: The word "all" by itself, without the quotation marks, is used to send each host's
information.
–database
<colon:separated:no_spaces>
When repeated, uses the last out_name.
TIP: This parameter is effective only if all the input records are parsed without error.
–fileout <out_name>
Outputs to the console unless redirected elsewhere.
TIP: This parameter is effective only if all the input records are parsed without error.
–streamout
Applies only when an output is selected.
TIP: The software ignores an incoming header line in an input file or stream-in.
–header
Sends the configuration records to the management station.
TIP: This parameter is effective only if all the input records are parsed without error.
–send
In the form http://servername or https://servername.
TIP: You can use https if your management station is set up for SSL.
–ms
<management_station_name>
The user name and password are the same as for the Configuration tab.–auth <user:password>
USERHOSTCFG 29