Emulex OneCommand Manager Application User Manual (P006979-01A Version 5.2, August 2011)

The OneCommand Manager User Manual Page 164
If you make changes you must click OK to save the changes and close the dialog box. You can click
Cancel and close the dialog box without saving the changes.
x86 Boot Advanced Adapter Settings dialog box
Using this dialog box, you configure advanced settings for the selected x86 adapter. All checkboxes are
cleared (off) by default. All changes require a reboot to activate.
Figure 97: x86 Boot Advanced Adapter Settings dialog box
x86 Boot Advanced Adapter Settings Definitions
• Enable Start unit command - Issues the SCSI start unit command. You must know the specific
LUN to issue.
• Enable EDD 3.0 - Enables the Enhanced Disk Drive (EDD) option (shows the path to the boot
device). Available on Intel Itanium servers only.
• Enable spinup delay - If at least one boot device has been defined, and the spinup delay is
enabled, the BIOS searches for the first available boot device.
• If a boot device is present, the BIOS boots from it immediately.
Note: If you do not enter the advanced settings and the configuration for the boot type is
new, default values are used. The default settings are given with descriptions of the
Advanced Adapter Settings dialog boxes in the following sections.
Note: An x86 series system could hang during Windows 2000 Server installation if EDD 3.0
is enabled.