Emulex OneCommand Manager Application User Manual (P006979-01A Version 5.2, August 2011)

The OneCommand Manager User Manual Page 196
SetPortEnabled
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd SetPortEnabled <WWPN|MAC> <PortEnable>
Description: This command enables or disables the FC or CNA port.
Parameters:
WWPN - Adapter’s WWPN
MAC - MAC address of the NIC or iSCSI port
PortEnable -
0 for Disable
1 for Enable
Authentication Commands
AuthConfigList
Supported by: Windows, Solaris and Linux
Syntax:
hbacmd AuthConfigList <WWPN>
Description: This command returns the list of WWPNs that have an authentication connection
configuration with the specified adapter.
Parameters:
WWPN - Adapter’s WWPN
DeleteAuthConfig
Supported by: Windows, Solaris and Linux
Syntax:
hbacmd DeleteAuthConfig <WWPN1> <WWPN2> <PasswordType> <Password>
Description: This command deletes the authentication configuration on the adapter.
Note: Ensure all I/O on the port is stopped, before disabling the port.
Note: When the SetPortEnabled command disables an FC port, the adapter must be
reset to activate the new setting. Only OneConnect™ adapters do not require a reset
when the adapter port is enabled or disabled.
Note: Authentication commands are supported on FC adapter ports only.