Emulex OneCommand Manager Application User Manual (P006979-01A Version 5.2, August 2011)

The OneCommand Manager User Manual Page 202
Pausetype - 1 = Standard, 2 = Per Pause Priority
pfcflag - 0 = Clear, 1= Set
pfcpriority - (0-0xff)
fcoepriority - (0-7)
fcoeformat - (0 or 0x10000)
Uifporttype - 1 = Access, 2 = Trunk
Value - Parameter Value
Where multiple values are possible, they should be specified using comma separated values.
Data Center Bridging Commands
GetDCBParams
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd GetDCBParams <WWPN|MAC>
Description: This command shows the Internal Host PFC flag value and DCBX mode ( DCB version),
as well as, the LLDP state for iSCSI, FCoE and NIC CNAs.
Parameters:
WWPN - Adapter’s WWPN
MAC - MAC address of the NIC or iSCSI port
Example:
hbacmd h=10.192.203.154 getdcbparams 00-00-c9-93-2f-d8
GetPGInfo
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd GetPGInfo <WWPN|MAC>
Description: This command shows the bandwidth percentages for all the priority groups for the port.
Additionally, this command displays the number of priority groups supported by an adapter.
Note: Data Center Bridging (DCB) commands are for DCB management of
OneConnect adapters only.
Note: For managing ESX/ESXi hosts from a Windows client, add the m=cim option to
the command. The default CIM credentials must be set using the SetCimCred
command. See “SetCimCred” on page 244.
Note: For managing ESX/ESXi hosts from a Windows client, add the m=cim option to
the command. The default CIM credentials must be set using the SetCimCred
command. See “SetCimCred” on page 244.