Emulex OneCommand Manager Application User Manual (P006979-01A Version 5.2, August 2011)

The OneCommand Manager User Manual Page 241
CnaGetEventLog
Supported by: Windows, Linux and VMware ESX
Syntax:
hbacmd CnaGetEventLog <WWPN|MAC>
Description: This command shows the CNA event log specified by the WWPN or MAC address.
Parameters:
WWPN: Adapter’s WWPN port
MAC - MAC address of the NIC or iSCSI port
Download
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd Download <WWPN|MAC> <FileName>
Description: Loads the firmware image to the FC or CNA port specified by the WWPN or MAC address.
Parameters:
WWPN - Port’s WWPN
MAC - The MAC address of the NIC or iSCSI port
FileName - The name and location of the firmware image (any file accessible to the CLI client)
ExportSANInfo
Supported by: Windows, Solaris Linux and VMware ESX
Syntax:
hbacmd ExportSANInfo [format]
Note: Supported for OneConnect adapters only.
Note: For managing ESX/ESXi hosts from a Windows client, add the m=cim option to
the command. The default CIM credentials must be set using the SetCimCred
command. See “SetCimCred” on page 244.
Note: For OneConnect adapters, while the WWPN or MAC address is used to identify
the adapter, the updated firmware applies to all ports on that adapter. It is not
necessary to download the firmware on all the adapter ports of a OneConnect
adapter.
Note: Emulex recommends that you redirect this output to a file with proper
extension, '.xml' for XML-formatted files and '.csv' for CSV-formatted files.
Note: Due to the amount of information that must be obtained and reported, this
command can take a long time on large SAN configurations.