Compaq StorageWorks Getting Started RAID Array 3000 for Microsoft Windows Installation Guide (AA-RACZD-TE, January 2001)

C-8 Getting Started RAID Array 3000 for Microsoft Windows Installation Guide
Compaq Confidential – Need to Know Required
Writer: Bob Young Project: Getting Started RAID Array 3000 for Microsoft Windows Installation Guide Comments:
Part Number: AA-RACZD-TE File Name: -appc Usage Notes and Troubleshooting.doc Last Saved On: 12/5/00 7:31 AM
Pager Notification and Event Logging Continues
After Exiting the Command Console Client
You may experience continuous paging notification and Windows NT event
logging in response to subsystem faults, even though you have exited
Command Console Client. This behavior is normal. It is the result of Client
starting the paging and event logging activity while it was running.
Client’s asynchronous event service (AES) module runs under Windows NT
and Windows 2000 as a service. It continues to run, even after you have exited
the program. The AES module communicates with Agents, and it activates
paging and event logging when a subsystem event occurs.
NOTE: When you stop AES on a client system, you are telling the Agent software to no
longer send updates to that client system.
To stop paging and event logging on a client system, perform the following for
Windows NT:
■ Go to Start|Settings|Control Panel|Services. Select AsyncEventSvc
(stands for asynchronous event service), and then click Stop.
Some Graphics Do Not Scale Well with
Large Fonts
It is recommended that small fonts be displayed when using the SWCC client
software on Windows NT and Windows 2000. Some of the graphics do not
scale as well when large fonts are used.