Compaq StorageWorks Getting Started RAID Array 3000 for Microsoft Windows Installation Guide (AA-RACZD-TE, January 2001)

4-4 Compaq StorageWorks Getting Started RAID Array 3000 for Microsoft Windows Installation Guide
Compaq Confidential – Need to Know Required
Writer: Bob Young Project: Compaq StorageWorks Getting Started RAID Array 3000 for Microsoft Windows Installation Guide Comments:
Part Number: AA-RACZD-TE File Name: e-ch4 Installing the Host Adapter.doc Last Saved On: 11/28/00 10:14 AM
Installing the SWXA3–BD SCSI Host
Adapter
To install the host adapter:
1. Shut down the operating system running on your host computer.
2. When the operating system has shut down, turn off the power to the host
computer and all attached peripherals. Then, disconnect power cables
from the host computer.
WARNING: Failure to remove power from the host computer and peripherals
can introduce a personal hazard, or can result in damage to the host computer
or loss of stored data.
3. Open the computer to gain access to the motherboard. Refer to your
computer system manual for assistance in completing this procedure.
4. Locate an available PCI expansion slot, and remove the blank filler
panel corresponding to that expansion slot at the rear of the system.
Retain the screw that held it in place. You need the screw to secure the
SWXA3–BD adapter as specified in step 5 of this procedure.