Compaq StorageWorks Getting Started RAID Array 3000 for Microsoft Windows Installation Guide (AA-RACZD-TE, January 2001)

5-2 Getting Started RAID Array 3000 for Microsoft Windows Installation Guide
Compaq Confidential – Need to Know Required
Writer: Bob Young Project: Getting Started RAID Array 3000 for Microsoft Windows Installation Guide Comments:
Part Number: AA-RACZD-TE File Name: f-ch5 Preparing Your Host for Use with Your RAID Array 3000.doc Last Saved On: 11/28/00 10:14 AM
NOTE: Keeping the 2944UW BIOS enabled might interfere with the system boot path. If
you are not using the RAID Array 3000 as the boot device for Windows NT, you can
disable the 2944UW BIOS; to do so set Host Adapter BIOS to Disabled.
7. Save the configuration and exit the BIOS setup.
To install the SWXA3–BD/Ultra PCI miniport device driver:
NOTE: Your adapter package includes the required adapter-specific software. Use only
the adapters and drivers supplied with the adapter kit since these are tested and certified
to function with the RAID Array 3000 Controller (HSZ22).
1. Open Control Panel.
2. Open SCSI Adapters from the Control Panel.
3. Select Drivers tab and then click Add.
4. Select Have Disk.
5. Insert the diskette labeled Adaptec 7800 family driver set into the floppy
diskette drive.
6. Specify the path to the NT driver, type: A:\WINNT\4_0 (for WINNT 4.0)
and click OK.
7. Select Adaptec AHA–294x/AHA–394x or AIC–78xx PCI SCSI
Controller from the SCSI Adapter List and click OK.
8. At this point the system prompts you to reboot. Ignore the instruction
and proceed to section “Installing the RAID Device Driver
(HSZDISK.SYS driver”). Reboot after HSZDISK.SYS has been
installed.