Compaq StorageWorks Getting Started RAID Array 3000 for Microsoft Windows Installation Guide (AA-RACZD-TE, January 2001)

Communicating Over a Network with Windows NT and Windows 2000 9-3

Compaq Confidential – Need to Know Required

Writer: Bob Young Project: Getting Started RAID Array 3000 for Microsoft Windows Installation Guide Comments:

Part Number: AA-RACZD-TE File Name: k-ch9 Communicating Over a Network with Windows NT and Windows 2000 .doc Last Saved On: 12/5/00 7:12

■

You need password protection for Agent’s host system. You may

specify a password during the Agent’s installation routine.

■ You will also need the IP name of Command Console Client’s host

system and you need a name for the storage subsystems connected to the

Agent’s Window NT host system.

■ You need to have installed TCP/IP services on your NT server.

■ You need to have created a Communications virtual disk on your RAID

Array 3000 using Command Console Client and a serial port

connection. See Chapter 6 “Installing Command Console Client and

Creating Your First Virtual Disk”.

■ You need to have assigned a Windows NT drive letter to the

Communications virtual disk using the Disk Administrator.

See Chapter 7 “Completing Your Storage Configuration Under

Windows NT”.

Installing the Agent

1. Place the RAID Array 3000 Software for NT/Intel/PCI CD–ROM in

your storage subsystem’s host system CD–ROM drive.

2. The Agent is located in D:\SWCC. Double-click the Setup icon to

begin the setup procedure.