Brocade Fabric OS Message Reference - Supporting Fabric OS v5.3.0 (53-1000437-01, June 2007)

122 Fabric OS Message Reference
53-1000437-01
FCR-1021
20
To do that, perform the following steps:
1. Run portDisable to disable all the EX_Ports that got this error message.
2. Run portDisable to disable all the other EX_Ports on that FCR connected to the same edge
fabrics the EX_ports disabled in step 1 are connected to.
3. Use Zoning commands on the edge fabrics, to reduce the LSAN zone entries on the edge
fabrics.
4. Run portEnable on each EX_Port, one at a time, to reenable the EX_Ports, and verify that this
error is not reported again.
Severity WARNING
FCR-1021
Message <timestamp>, [FCR-1021], <sequence-number>,, WARNING, <system-name>, Local LSAN
device entries exhausted.
Probable Cause Indicates that the number of devices created through logical storage area network (LSAN) zones
within the MetaSAN exceeds the local LSAN zone database limitations.
Recommended
Action
Remove excess device entries within LSAN zones so that the number of devices is within the range
of the local zone database limitations.
Severity WARNING
FCR-1022
Message <timestamp>, [FCR-1022], <sequence-number>,, ERROR, <system-name>, Local proxy
device slot entries exhausted.
Probable Cause Indicates that the resources used to persistently store the proxy device slot to the remote
world-wide name (WWN) have been consumed.
Recommended
Action
Remove the proxy device slots by using the fcrProxyConfig command or limit proxy devices by
removing logical storage area network (LSAN) zone entries.
Severity ERROR
FCR-1023
Message <timestamp>, [FCR-1023], <sequence-number>,, WARNING, <system-name>, Local
phantom port WWN entries exhausted.
Probable Cause Indicates that the number of port world-wide names (WWNs) in use exceeds the local port WWN
resources.