Brocade Fabric OS Message Reference - Supporting Fabric OS v5.3.0 (53-1000437-01, June 2007)

230 Fabric OS Message Reference

53-1000437-01

FW-1434

Message <timestamp>, [FW-1434], <sequence-number>,, WARNING, <system-name>, Switch status

change contributing factor Blade:

<Number Bad> blade failures.

Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the number of

blade failures is greater than or equal to the policy set by the switchStatusPolicySet command.

Recommended

Action

Replace the faulty blade.

Severity WARNING

FW-1435

Message <timestamp>, [FW-1435], <sequence-number>,, WARNING, <system-name>, Switch status

change contributing factor Flash: usage out of range.

Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the flash usage is

out of range. The policy was set using the switchStatusPolicySet command.

Recommended

Action

Run the supportSave command to clear out the kernel flash. Refer to the Fabric OS Command

Reference for more information about this command.

Severity WARNING

FW-1436

Message <timestamp>, [FW-1436], <sequence-number>,, WARNING, <system-name>, Switch status

change contributing factor Marginal ports: <Num of marginal ports and the port

numbers> marginal ports. (Port(s) <Unknown>)

Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the number of

marginal ports is greater than or equal to the policy set using the switchStatusPolicySet command.

A port is faulty when the port value for Link Loss, Synchronization Loss, Signal Loss, Invalid word,

Protocol error, cyclic redundancy check (CRC) error, Port state change or Buffer Limited Port is

above the high boundary.

Recommended

Action

Replace any faulty or deteriorating small form-factor pluggables (SFPs).

Severity WARNING