Brocade Fabric OS Message Reference - Supporting Fabric OS v5.3.0 (53-1000437-01, June 2007)

296 Fabric OS Message Reference
53-1000437-01
MS-1009
48
MS-1009
Message <timestamp>, [MS-1009], <sequence-number>,, ERROR, <system-name>, RLIR event.
Switch Port ID is <PID>. Device Port Tag is <port tag>. <message>.
Probable Cause A Registered Link Incident Record (RLIR) has been generated for one of the actions clarified by the
<message> passed in.
The following messages might be displayed:
• Exceeded bit error rate threshold
• Loss of signal or synchronization
• Not operational seq. recognized
• Primitive sequence timeout
• Unrecognized link incident
Recommended
Action
Persistent RLIR incidents are likely due to SAN hardware problems such as bad cables, small
form-factor pluggables (SFPs), etc. It may be necessary to replace hardware if these messages
persist.
Severity ERROR
MS-1021
Message <timestamp>, [MS-1021], <sequence-number>,, ERROR, <system-name>, MS WARMBOOT
failure(FSS_MS_WARMINIT failed. Reason=
<failure reason>)
Probable Cause Indicates that the Fabric OS state synchronization (FSS) warm recovery failed during WARM INIT
phase of a reboot.
Recommended
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
MS-1022
Message <timestamp>, [MS-1022], <sequence-number>,, INFO, <system-name>, Management
Server Platform Service
<Activated or Deactivated>
Probable Cause Indicates that Management Server Platform Service is being activated or deactivated.
Recommended
Action
No action is required.
Severity INFO