Brocade Fabric OS Message Reference - Supporting Fabric OS v5.3.0 (53-1000437-01, June 2007)

354 Fabric OS Message Reference
53-1000437-01
SEC-1083
63
SEC-1083
Message <timestamp>, [SEC-1083], <sequence-number>,, ERROR, <system-name>, Name already
exists.
Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can
only occur when the primary fabric configurations server (FCS) is distributing the security database
to the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR
SEC-1084
Message <timestamp>, [SEC-1084], <sequence-number>,, ERROR, <system-name>, Name exists
for different type
<Policy name>.
Probable Cause Indicates that the specified policy already exists.
Recommended
Action
No action is required.
Severity ERROR
SEC-1085
Message <timestamp>, [SEC-1085], <sequence-number>,, ERROR, <system-name>, Failed to
create
<policy name>.
Probable Cause Indicates that the security policy was not created.
Recommended
Action
Check that the current policy configuration is valid. For example, the RSNMP policy cannot exist
without the WSNMP policy.
Severity ERROR