Brocade Fabric OS Message Reference - Supporting Fabric OS v5.3.0 (53-1000437-01, June 2007)

360 Fabric OS Message Reference
53-1000437-01
SEC-1101
63
SEC-1101
Message <timestamp>, [SEC-1101], <sequence-number>,, ERROR, <system-name>, Failed to
enable security on all switches. Please retry later.
Probable Cause Indicates that the security enable failed on the fabric because one or more switches in the fabric
are busy.
Recommended
Action
Verify that the security event was planned. If the security event was planned, run the
secFabricShow command to verify that all switches in the fabric are in the ready state. When all
switches are in the ready state, retry the operation.
Severity ERROR
SEC-1102
Message <timestamp>, [SEC-1102], <sequence-number>,, ERROR, <system-name>, Fail to
download
<security data>.
Probable Cause Indicates that the switch failed to download certificate, security database, or policies. This can
happen when switch does not get enough resources to complete the operation, fabric has not
stabilized, or policy database is an invalid format.
Recommended
Action
Wait for fabric to become stable and then retry the operation. If the policy database is in an illegal
format (with configDownload), correct the format and retry the operation.
Severity ERROR
SEC-1104
Message <timestamp>, [SEC-1104], <sequence-number>,, ERROR, <system-name>, Fail to get
primary
<Certificate or public key>.
Probable Cause Indicates that the switch failed to get either the primary certificate or a primary public key.
Recommended
Action
Verify that the primary switch has a valid certificate installed and retry the operation. If a valid
certificate is not installed, install a certificate by following the procedure specified in the Secure
Fabric OS Administrator's Guide.
Severity ERROR