Brocade Fabric OS Message Reference - Supporting Fabric OS v5.3.0 (53-1000437-01, June 2007)

448 Fabric OS Message Reference

53-1000437-01

ZONE-1018

Message <timestamp>, [ZONE-1018], <sequence-number>,, ERROR, <system-name>, Incorrect

zoning enforcement type(<zone type>) at port(<port number>).

Probable Cause Indicates that an incorrect zoning enforcement type was reported on the specified port. This is a

software error. A QuickLoop zone type (value = 4) or an uninitialized type (value = 0) are invalid.

The valid zone type values are:

• hard port zone (value = 1)

• hard wwn zone (value = 2)

• session based hard zoning (value = 3)

• FA zone (value = 5)

QuickLoop zones are not supported in Fabric OS v4.x and above.

Recommended

Action

If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the

supportSave command and contact your switch service provider.

Severity ERROR

ZONE-1019

Message <timestamp>, [ZONE-1019], <sequence-number>,, ERROR, <system-name>, Transaction

Commit failed. Reason code <reason code> (<Application reason>) - \"<reason

string>\"

Probable Cause Indicates that the reliable commit service (RCS) had a transmit error. RCS is a protocol used to

transmit changes to the configuration database within a fabric.

Recommended

Action

Often this message indicates a transitory problem. Wait a few minutes and retry the command.

Make sure that your changes to the zone database are not overwriting the work of another admin.

Run the cfgTransShow command to find out if there is any outstanding transaction running on the

local switches.

If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the

supportSave command and contact your switch service provider.

Severity ERROR