Brocade Fabric OS Message Reference - Supporting Fabric OS v5.3.0 (53-1000437-01, June 2007)

Fabric OS Message Reference 451

53-1000437-01

ZONE-1028

Message <timestamp>, [ZONE-1028], <sequence-number>,, WARNING, <system-name>, Commit zone

DB larger than supported - <zone db size> greater than <max zone db size>.

Probable Cause Indicates that the zone database size is greater than the limit allowed by the fabric. The limit of the

zone database size depends on the lowest level switch in the fabric. Older switches have less

memory and force a smaller zone database for the entire fabric.

Recommended

Action

Edit the zone database to keep it within the allowable limit for the specific switches in your fabric.

Refer to the Fabric OS Administrator’s Guide for information on the zone database sizes supported

for each switch.

Severity WARNING

ZONE-1029

Message <timestamp>, [ZONE-1029], <sequence-number>,, WARNING, <system-name>, Restoring

zone cfg from flash failed - bad config saved to <config file name> [<return

code>].

Probable Cause Indicates that the zone configuration restored from the flash was faulty.

Recommended

Action

This error will save the faulty zone configuration in the zoned core file directory.

If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the

supportSave command and contact your switch service provider.

Severity WARNING

ZONE-1030

Message <timestamp>, [ZONE-1030], <sequence-number>,, WARNING, <system-name>, Converting

the zone db for PID format change failed.

Probable Cause Indicates that the current zone database could not be converted to reflect the PID format change.

Most likely this is caused by the size of the zone database.

Recommended

Action

Change the PID format back to its original format. Reduce the size of the zone database. Then you

can change the PID format to the requested format.

Severity WARNING