Brocade Web Tools Administrator's Guide (53-0000194-01, November 2006)

Web Tools Administrator’s Guide 7-15
Publication Number: 53-0000194-01
7
To edit an IP route
1. Click a port in the Switch View to launch the Port Management module in a separate window (see
Figure 5-1 on page 5-2).
2. Click the GigE Ports subtab.
3. Click the port you want to edit and click the IP Routes subtab.
4. Select the IP route to edit in the table on the right side of the window.
5. Click Edit in the task bar.
The Edit IP Route dialog box displays, populated with the current configuration values. Retype the
metric for the IP Route.
6. Click OK.
To delete an IP route
1. Click a port in the Switch View to launch the Port Management module in a separate window (see
Figure 5-1 on page 5-2).
2. Click the GigE Ports tab and click the port you want to edit.
3. Click the IP Routes subtab.
4. Select the IP route to delete in the table on the right side of the window. Use Shift-click and Ctrl-
click to select multiple IP routes.
5. Click Delete in the task bar.
6. Click Yes in the confirmation window.
Managing FCIP Tunnels
To configure FCIP tunnels, you must specify the following attributes:
• IP address of the remote switch
• IP address of the local interface
• Whether the tunnel rate is uncommitted or committed and, if committed, the committed rate for the
tunnel
Uncommitted rate tunnels use a minimum of 1000 Kb/sec, up to a maximum of the available
uncommitted bandwidth on the GbE port.
• (Optional) WWN of the remote switch
• Whether compression, fastwrite, tape pipelining, or an IKE/IPSec policy is enabled or disabled.
These are all features of FCIP.
N
ote
Before you can delete an IP route, you must first delete the corresponding FCIP tunnel.