32 Installation Guide (AA-RVULC-TE, January 2005)

SAN Switch technical specifications108

Table 32 describes the cable pinouts.

A 10-foot (3.0-m) serial cable is provided with the switch. It can be converted from a DB–9

serial cable to an RJ–45 serial cable by removing the adapter on the end of the cable.

To remove the adapter from the end of the DB–9 serial cable:

1. Ensure the cable and both screws have been disengaged.

2. Pull the adapter straight out, without moving it from side to side, to loosen seating of the

connector. If you move the adapter side to side, you might damage the it.

CAUTION: When removing the DB–9 male connector from the DTE port, do not use

excessive force; otherwise the DB–9 connector will split into two parts easily so that the

switch’s DTE port is not damaged.

Table 32 Cabling pinouts

Pin Signal Description

1 Not supported Not supported

2 RxData Receive data

3 TxData Transmit data

4 Not supported Not supported

5GND Logic ground

6 Not supported Not supported

7 Not supported Not supported

8 Not supported Not supported

9 Not supported Not supported