32 Installation Guide (AA-RVULC-TE, January 2005)

Overview24

Table 4 lists the SAN Switch 4/32 nonport side components.

Upgrading SAN Switch 4/32 ports

The SAN Switch 4/32 is available with either sixteen ports, 0 through 15 (Base model) or

thirty two, ports 16 through 32 (Full model) activated.

To activate additional ports, contact your HP representative to purchase the

HP StorageWorks

8-Port Upgrade License

, Part Number T3677A. For example, if your SAN Switch 4/32 shipped

with sixteen active ports, purchase one 8-Port Upgrade License to activate ports 16 through 23.

Purchase two 8-Port Upgrade Licenses to activate ports 24 through 32.

NOTE: Check port status to verify if the license is pre-installed. For example, use the

portshow command for ports 16 through 32. If the port status output indicates “Started” and

“Licensed”, then all thirty two ports are activated.

1. If ports 16 through 32 show no License, purchase the

HP StorageWorks 8-Port Upgrade

License,

Part Number T3677A, from an authorized HP representative.

Your HP representative requires the SAN Switch 4/32’s World Wide Number (WWN) in

order to assign a license key. Enter the switchshow command to obtain the WWN of

your SAN Switch 4/32.

2. Install the

HP StorageWorks 8-Port Upgrade License

. The license key is a string of

approximately sixteen uppercase and lowercase letters and digits.

a. Log in to the SAN Switch 4/32 as admin.

b. Enter the licenseadd command, followed by the license key enclosed in quotation

marks.

Table 4 SAN Switch 4/32 nonport side components

Number Description

1 Power supply 2

2 Fan 3

3 Fan 2

4 Fan 1

5 Power supply 1