32 Installation Guide (AA-RVULC-TE, January 2005)

Installing and configuring36

Installing as a stand-alone device

Follow these steps to install as a stand-alone unit.

1. Unpack the switch and verify that all items listed on ”SAN Switch shipping carton contents”

on page 32 are present and undamaged.

2. Locate the four rubber feet in the Accessory box.

3. Apply the adhesive rubber feet. Applying the rubber feet in the switch helps prevent the

switch from sliding off the supporting surface.

a. Clean the indentations at each corner of the bottom of the switch to ensure that they are

free of dust or other debris that might lessen the adhesion of the feet.

b. With the adhesive side against the chassis, place one rubber foot in each indentation

and press into place.

4. Place the switch on a flat, sturdy surface.

5. Apply power to the switch as described in ”Powering on and off” on page 62.

CAUTION: Do not connect the switch to the network until the IP address is correctly set. For

instructions on how to set the IP address, see ”Cabling and configuring the SAN Switch” on

page 50.