32 Installation Guide (AA-RVULC-TE, January 2005)

Installing and configuring44

• For an HP System/e rack, install two #10-32 x 1/2-inch Phillips pan-head screws

with captive star lock washers and two #10 alignment washers in the upper and

lower hole locations of the right rail. Then install two #10-32 x 1/2-inch Phillips

pan-head screws with captive star lock washers and two #10 alignment washers in

the upper and lower hole locations of the left rail. See Figure 11.

Figure 11 Assembling the outer rails (HP System/e rack)

5. The SAN Switch Rack Mount Kit provides different screw types for securing the inner rails.

Specific switches require a different number of these screws. See Table 8 to determine the

appropriate number of screws.

CAUTION: Do not use any screws other than the ones provided. Use of any longer lengths

can cause damage to internal components.