32 Installation Guide (AA-RVULC-TE, January 2005)

Installing and configuring52

NOTE: Figure 17 shows the SAN Switch 2/16V. This procedure is the same for all SAN

Switches.

Figure 17 Connecting the serial cable to a SAN Switch 2/16V

NOTE: If the serial port on the workstation uses an RJ-45 connector instead of an RS-232,

remove the adapter on the end of the serial cable and insert the exposed RJ-45 connector into

the RJ-45 serial port on the workstation.

3. Disable any serial communication programs running on the workstation.

4. Open a terminal emulator application (such as HyperTerminal on a PC or TERM in a UNIX

environment) and configure the application as follows:

• In a Windows 95, 98, 2000, or NT environment:

• In a UNIX environment, type the following string at the prompt:

tip /dev/ttyb -9600

Bits per

second

9600

Databits 8

Parity None

Stop bits 1

Flow control None

0014a

IOIOI

100-240

VAC

-6

C 1.0A 47-63Hz

100-240

VAC

C 1.0A 47-63Hz