HP StorageWorks SAN Switch 2/8V, 2/16V, 2/16N and 4/32 Installation Guide (AA-RVULC-TE, January 2005)

53SAN Switch 2/8V, 2/16V, 2/16N and 4/32 installation guide
Logging in
Once a serial connection is established, apply power to the switch.
1. Connect the power cords to both power supplies and power sources, as shown in
Figure 18.
NOTE: The SAN Switch 2/8V uses one power cord, all other SAN Switches use two.
Figure 18 Connecting SAN Switch 2/16V power cords
NOTE: To protect against AC failure, connect the power cords to outlets on separate circuits.
Verify that the cords have a minimum service loop of six inches available at the connection to
the switch and are routed to avoid stress.
2. To power on, set the two AC switches to 1.
NOTE: The SAN Switch 2/8V uses only one power switch.
3. The power supply LED lights up green, and the switch runs POST. The switch requires a
minimum of three minutes to boot and complete POST.
4. After POST and the boot process completes, verify that the System Status and Power Status
LEDs light green.
0015a
IOIOI
IOIOI
1
0
0
-
2
4
0
100-240
VAC
1
.0
A
4
7
-
6
3
H
z
C 1.0A 47-63Hz
1
0
0
-2
4
0
100-240
VAC
1
.0
A
4
7
-
6
3
H
z
C 1.0A 47-63Hz
!