16N Installation Guide, V4.2.X (AA-RVULB-TE, April 2004)

Installing the SAN Switch

31SAN Switch 2/8V, 2/16V and 2/16N Installation Guide

Installing a Stand-Alone SAN Switch 2/8V, 2/16V and 2/16N

To install the SAN Switch as a stand-alone unit, follow the procedure described

here:

1. Unpack the switch and verify that all items listed on “Shipping Carton

Contents” on page 27 are present and undamaged.

2. Apply the adhesive rubber feet. Applying the rubber feet in the switch helps

prevent the switch from sliding off the supporting surface.

a. Clean the indentations at each corner of the bottom of the switch to ensure

that they are free of dust or other debris that might lessen the adhesion of

the feet.

b. With the adhesive side against the chassis, place one rubber foot in each

indentation and press into place.

3. Place the switch on a flat, sturdy surface.

4. Provide power to the switch as described in “Powering the Switch On and

Off” on page 58.

Caution: Do not connect the switch to the network until the IP address is

correctly set. For instructions on how to set the IP address, see “Cabling and

Configuring the SAN Switch 2/8V, 2/16V or 2/16N” on page 47.