16N Installation Guide, V4.2.X (AA-RVULB-TE, April 2004)

Installing the SAN Switch

34 SAN Switch 2/8V, 2/16V and 2/16N Installation Guide

Installing the Switch in a Rack Using the SAN Switch Rack Mount Kit

This section provides instructions for installing the switch in an HP System/e

cabinet, or in an HP 10000 series cabinet using the HP StorageWorks SAN Switch

Rack Mount Kit supplied with your switch. The Rack Mount Kit installation

requires one technician to install a SAN Switch.

Note: The Rack Mount Kit installation requires one technician.

The following items are required to install the switch in a cabinet:

■ SAN Switch 2/8V, SAN Switch 2/16V or SAN Switch 2/16N

■ Power cables

■ #2 Phillips screwdriver

■ 7/16-inch wrench or socket

The SAN Switch Rack Mount Kit rails and rail mounting hardware listed in

Table 6:

Table 6: Rack Mount Kit rails and rail mounting hardware

Item Description

(2) rear mounting brackets

A right inner rail and a right outer rail

A left inner rail and a left outer rail