16N Installation Guide, V4.2.X (AA-RVULB-TE, April 2004)

Installing the SAN Switch

37SAN Switch 2/8V, 2/16V and 2/16N Installation Guide

To install the switch in a rack:

1. Check contents of the shipping carton to verify all the required parts and

hardware are available.

2. Choose a mounting location in the rack for the switch.

3. Attach the rear mounting brackets to the rear rack uprights by completing one

of the following steps:

— For an HP 10000 series or comparable EIA cabinet, assemble each of the

two brackets with (2) #10-32 x 1/2-inch Phillips pan-head screws with

captive star lock washers and (2) #10 adapter washers as shown in

Figure 5.

Figure 5: Installing the rear mounting brackets (HP 10000 series or comparable EIA

cabinet)

— For an HP System/e rack, install each of the two rear mounting brackets

with (2) #10-32 x 1/2-inch Phillips pan-head screws and (2) #10

alignment washers as shown in Figure 6.